Seller's Comments:
Attention prospective new and current Matco Distributors: this truck was originally designed and built for a new Matco Distributor. All you have to do to use it for Matco Tools sales again is to put the decals back on. I will buy the decals for you if you buy my truck! You have them installed.
I am extending this offer to any tool company dealer - I will buy the decals, you install them.
Plus, Trans Lease will lease this truck to you.
This truck has a lot of options!
Extra Shelving:
3 additional removable custom shelves
made of Red Oak that fill in where the 2 bay box opening would
be making that entire opening removable to accomodate a top
and bottom box or all shelves. See the very bottom of the photos to see the shelves/ There is an 8' x 2' shelf above
the 3 bay opening that is great for POS display items as it
is installed "level" with no pitch. Above, there is
another custom Red Oak shelf installed flat...Both of these
shelves can be removed if so desired to accomodate a 3 bay with
top or hutch.The additional shelving offered with this truck
is an unbelievable display upgrade to allow quantity and diversity
of promo items and change overall appearence of the truck and
inventory. If you think you're maxed out for display space...
add up to 3 more shelves in 20 min.
This truck features:
V8 Duramax Diesel Engine - pre emissions, no catalytic converter
5 speed Allison automatic transmission
Dual alternators
Dual AC Compressors
5 Red Oak shelves per side
White ceiling with black lace (all good none broken)
Gray carpeted walls and shelves
Diamond plate step entry w/easy access battery box
Rear and right side outside spot lights
Fire extinguisher
Hammer rack
Creeper storage
2 jack storage openings
3 floor height drawers
LP FUEL rear heat w/thermostat controls
L Shaped Oak Desk w/6 drawers
Catalog rack w/predrilled printer wire holes
Knife display
3 catalog and promo racks
Hardwood flooring
12 v recepticals/and 115v a/c recepticals
1000 watt inverter
Shore line power converter
Lighting working and with new high intensty bulbs
Pre wired wired for additional lighting
Full Walk-Through with sliding locking door
Air-drivers seat
New Batteries in box
New rear brakes last year/ fronts are perfect
Large Dock Height lift gate
Double rear doors
Sliding side door (a must for areas where double parking is required)
Yale deadbolt lock
Fully alarmed with motion detectors
Rear A/C
Heated power mirrors w/ turn signals
New front shocks last year
Regular PM's from a Pine Aire Truck in Bayshore NY
3,000 Mile oil changes
Fresh trans service/fuel filter/air filter completed last year
Gate and rear doors greased with PM's
Roof vent with 3 speed fan
As many ratchet straps as you need
D-Rings on floor
Additional e channel across rear doors for securing a 3rd. tool
box or 3 bay trade in.
1 camara and video monitor
Engine block heater
ICC bumper below chrome diamond plate rear tail light pannel
Lower body side skirts
Side step to box entry
Notes:
Right rear corner has a small dent common on C5500's and light
tree rubbings
needs a chrome center cap on right rear wheel...lost after rear
brake service.
The truck just passed NY State Inspection last week.
Started out it's career as a Matco Tools Truck. Easy for you to change it back to Matco or any other tool company truck with the installation of some decals.
